portroute.blogg.se

Irad 900 nount
Irad 900 nount












irad 900 nount

Put the voltmeter into VDC mode, to measure DC volts, turn the ignition to the on position.Ħ. Turn the ignition to the on position, then back to off, and make sure it beeps regardless of ignition position.ĥ. For each wire that beeps, that means that wire is grounded. Put the black probe on that ground, and touch the back of each exposed wire connector in the mirror harness with the red probe.Ĥ. Find a ground on the car somewhere, like a bolt under the dash, or a metal cross member.ģ.

irad 900 nount

First set your voltmeter to the continuity setting (should beep when you touch the red and black probes together, telling you they are shorted).Ģ. Guidelines on Using a Voltmeter to Locate Power and Groundġ. Voltmeter How do you check voltage with a Voltmeter?

irad 900 nount

8' Long Power cable w/DC connector and inline 2A fuse (replaceable).

#Irad 900 nount professional

This BlendMount Kit includes everything needed for a professional looking installation: Others: Visit your Dealer or local Car Audio Shop for installation. DIY'ers: Our installation instructions include the Step-by-Step VoltMeter process for determining the +12V Switch and Ground harness slots. Instead, a tight, protective sheathing with texture that looks factory, just like our MirrorTap Power Cords. This HardWire Kit for your Cobra, Uniden, K40, Radenso Whistler Radar Detector or BlackVue Dashcam is 8 feet in length and has an inline fuse so 12 Volt "ignition" power can be safely obtained from the nearest source.














Irad 900 nount